As per title hello from maidstone just bought my first golf and big smiles all round loads of history and receipts including all evidence and proof of all work listed UK car was sent to Germany , now back in UK and just insured by the vin along with tax and mot while waiting for uk v5 as , as u can c its still on german plates just bought a 1.8t agu 1999 Gates cam belt kit and metal impeller waterpump done Recaro black leather interior ( heated ) H&R lowering springs Remapped by AMD Essex Forge 007 Diverter Valve Apiro air filter 2,5" Stainless Steel Cat-Back Exhaust Upgraded front brake discs, calipers, carriers and pads (312mm Audi TT/S3 etc) Braided brake hoses New front wheel bearings After market headlights couple niggles boot only opens when put key in and turn sunroof tilts but apparently doesnt go all the way back so it aint been tested yet incase it rains lol , only tested tilt needs a cd player as cd changer in boot dont work may go for one above original stereo ( unless i can find an original cd to go above the standard stereo as likeing thee blue lighting doesnt have the centre panel in the clocks ( display etc ) has the stalk to adjust and view mpg , miles and temp though which can be seen below rev counter :mellow: needs headlight washers caps refitted on bumper loving the motor though any advice ?
Welcome to Club GTI. By the way there is the Kent meet occurring this Sunday right near you too! Details in this >>thread< at the Mickey's Rock Cafe. Start time 10am.
Nice clean Mk4 you have there As said above, a 4motion rear valance would house that exhaust nicely in the rear bumper.
you may need to raise you back box up as it looks like it sits below the standard lower bumper trim - hard to tell in the dark pics, so adding one with a cutout for the tailpipes will look weird as there will be a big space above the tailpipes into the empty cutout - if you see what i mean
personally id just get the anni or 4mo one and sort the exhaust, must look a little weird and low hanging under the standard valance
If you go for an anni one, bare in mind its designed for a single tailpipe. Small rear top spoiler would also set the back off nicely too.
anni would be fine as long as the tailpipes are huge, i have a 4motion in for breaking with an anni rear and the stock 4mo twin tails
Not 100% sure but I think both anni and 4mo are the same except for the exhaust exit. 4mo is wider to accomodate twin tail pipes. Anni is smaller for the single tail pipe.
all i can say is what is in my unit at the moment, and a 4mo exhaust fits in an anni valance the same as a std 4motion one