Big / small end dimensions and tolerances

Discussion in '8-valve' started by jrgibb, Jul 24, 2015.

  1. jrgibb

    jrgibb Forum Member

    Joined:
    Feb 17, 2008
    Likes Received:
    20
    Location:
    Kent
    Hi all,

    Does anyone know the big end dimensions on an AGG crank (053 105 101K) and the tolerances before fitting oversize bearings, also the inner dimensions for the small end bush and / or gudgeon pin diameter.

    Thanks,

    J
     
    jrgibb, Jul 24, 2015
    #1

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Accept Learn More...
    Dismiss Notice