** Mint Wishbones, Ball Joints and Tie Rods **

awsome,looks realy good,forgive me if its been mentioned,im too lazy to read it all atm,what car is this and what primer did you use,id love to do this to my mk2 when i replace the engine,chers

 

Hi matey,

It's a Mk3 VR6 (1997). I'd use a good Acid Etch primer if you want to spray it (eBay, etc.). But in hindsight if you want it done properly I'd get your subframe etc. to an engineering workshop, get the to shot blast it and then powder coat it. They can do many different colours too (even chrome ! ). Depends on the kind of finish you require !

 

cheers,no i dont want to go to that extreem tbh,only if i was to show the car(which i never will ) its just to tidy it up really,looks really good