VR5 Timing chain

Discussion in 'VR5, VR6 & Wx' started by NateS2, Apr 16, 2021.

  1. NateS2

    NateS2 Paid Member Paid Member

    Joined:
    May 1, 2019
    Likes Received:
    257
    Does anyone know if it would be possible for someone to fit the chains on a VR5 so that the exhaust cam is approx 2 teeth out, yet the engine still run seemingly fine?
    Its an AQN engine, and from the (very limited) information online, Group 90 and 91 should be reading as close to 0 degrees as possible at idle. The intake cam is reading about 3 degrees, the exhaust is -22 which doesn't seem right.
    I'm going to take the phase sensors out and look for the timing marks later, but just want to know if thats possible. Or are those values totally normal for an AQN?
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice