We have a problem Houston

whoah! that must have gone with a pop

 

I hope thats not yours

 

i don't know much about engines, but i'm sure i can see pistons and i'm pretty sure they shouldn't be visible?!

who's is it?!

 

Thats on a dyno isn't it?

 

geezer on the vortex. Was apparently running just over 1000hp at 10,000rpm+ before it went bang

 

clicky

 

Impressive.

Rods look strong, at least.

 

Isn't going for 1000bhp on a 4-cylinder engine just greedy?

 

very impressed with those rods!! if they can stick that they can stick anything

 

16VT

Ho Ho Ho

 

I will be finding out what pistons and rods that guy is using, roll on august when I get my bonus.

is that a dry sump system as well ?

 

I thought the same...
slipper pistons too.

 

Thats a serious flywheel....

It takes some doing to split a block in two...

There must have been a casting imperfection, it doesn't take much to cause a full failure when the block is put under stress.

 

Jeeeeesus!

 

oh my god

 

that's a serious ad for whatever those rods are!

 

and then they start debating drivetrain losses.....again

 

Anyone find out what rods these were??


Look like Carrillos.